A 200 synergic inverter MIG welder for single phase 230 V that also runs flux-cored wire, stick and lift TIG. Choose the wire and gas and it sets voltage and wire speed for you, and the 4-roll drive feeds steel, stainless and aluminium wire without crushing it.
A 40 air plasma cutter for single phase 230 V that cuts steel, stainless and aluminium up to 12 mm with a clean edge. The pilot arc starts without touching the plate, so painted, rusty and expanded metal cut easily, and the built-in regulator and filter protect the torch.
A compact 140 MMA inverter for single phase 230 V with hot start, arc force and anti-stick. It is light enough to carry up a ladder, runs on site generators and is forgiving with general-purpose and low-hydrogen electrodes, with lift TIG when you need it.
A 200 DC inverter TIG welder with high-frequency start, pulse, 2T/4T and nine job memories. It gives a clean, controllable arc on stainless, mild steel and, on AC/DC models, aluminium, and it also welds with stick electrodes.
A 250 synergic inverter MIG welder for single phase 230 V that also runs flux-cored wire, stick and lift TIG. Choose the wire and gas and it sets voltage and wire speed for you, and the 4-roll drive feeds steel, stainless and aluminium wire without crushing it.
A 60 air plasma cutter for single phase 230 V that cuts steel, stainless and aluminium up to 20 mm with a clean edge. The pilot arc starts without touching the plate, so painted, rusty and expanded metal cut easily, and the built-in regulator and filter protect the torch.
A compact 180 MMA inverter for single phase 230 V with hot start, arc force and anti-stick. It is light enough to carry up a ladder, runs on site generators and is forgiving with general-purpose and low-hydrogen electrodes, with lift TIG when you need it.
A 200 AC/DC inverter TIG welder with high-frequency start, pulse, 2T/4T and nine job memories. It gives a clean, controllable arc on stainless, mild steel and, on AC/DC models, aluminium, and it also welds with stick electrodes.
A 350 synergic inverter MIG welder for three phase 400 V that also runs flux-cored wire, stick and lift TIG. Choose the wire and gas and it sets voltage and wire speed for you, and the 4-roll drive feeds steel, stainless and aluminium wire without crushing it.
A 100 air plasma cutter for three phase 400 V that cuts steel, stainless and aluminium up to 35 mm with a clean edge. The pilot arc starts without touching the plate, so painted, rusty and expanded metal cut easily, and the built-in regulator and filter protect the torch.
A compact 250 MMA inverter for three phase 400 V with hot start, arc force and anti-stick. It is light enough to carry up a ladder, runs on site generators and is forgiving with general-purpose and low-hydrogen electrodes, with lift TIG when you need it.
A 315 AC/DC inverter TIG welder with high-frequency start, pulse, 2T/4T and nine job memories. It gives a clean, controllable arc on stainless, mild steel and, on AC/DC models, aluminium, and it also welds with stick electrodes.
A 400 synergic inverter MIG welder for three phase 400 V that also runs flux-cored wire, stick and lift TIG. Choose the wire and gas and it sets voltage and wire speed for you, and the 4-roll drive feeds steel, stainless and aluminium wire without crushing it.