FAQs
What size compressor do I need?
The compressor must deliver more free air than the air consumption in the specifications, at the stated pressure, with some margin. As a rough guide, the 40 A model needs a compressor of at least 3 hp and the 100 A model a belt-drive or rotary screw unit. Always fit a water separator.
Why are my tips wearing out quickly?
The usual causes are wet or oily air, low air pressure, touching the tip to the plate without a drag shield, and starting the arc too often in mid-air. Dry the air supply, check the pressure while cutting, and replace tip and electrode together.
Can it cut stainless and aluminium?
Yes. Plasma cuts any metal that conducts electricity. Aluminium cuts quickly but leaves a slightly rougher edge, and stainless gives a clean edge with very little heat discolouration.
Will the arc interfere with computers or CNC controls?
No high frequency is used to start the arc, so interference is much lower than with older HF plasma cutters. The 100 A model also has a CNC interface for connecting to a cutting table.
What eye protection do I need?
Use a filter of shade 5 to 8 depending on current, in goggles, a face shield or a welding helmet. An auto-darkening helmet set to shade 9 is fine for higher currents. Bystanders need protection too.
Are spare tips and electrodes available?
Yes, a starter set is in the box and replacement tips, electrodes and shields are sold in packs. Trade customers can save them to a quick order list so repeat orders take seconds.