Overview
This Arcvane MIG welder is built for fabrication shops, maintenance teams and site contractors who need one machine for most jobs. It welds solid steel, stainless and aluminium wire with gas, flux-cored wire without gas, and switches to stick or lift TIG when a job calls for it.
The synergic control does the set-up work. You pick the wire type, wire diameter and gas on the display, set the material thickness, and the machine matches voltage to wire speed. A trim control lets you fine-tune the arc by sound and finish.
Key features
- Synergic programs for steel, stainless, aluminium and flux-cored wire
- 4-roll geared wire drive, 15 kg spools
- MMA (stick) and lift-TIG modes
- Euro torch connector, 3-year warranty
Where to use it
The single phase models plug into a standard workshop supply or a suitably sized generator, which makes them a good fit for site repairs, agricultural work and smaller workshops. The three phase models have the duty cycle for long runs on structural steel, trailers, plant repairs and production work.
- Sheet metal and vehicle panels from 0.8 mm
- Gates, railings, frames and general fabrication
- Structural steel and heavy plate on the three phase models
- Aluminium with a PTFE liner and U-groove rolls
- Outdoor work with self-shielded flux-cored wire
Design and construction
The wire drive is a geared 4-roll unit on a cast frame, so feed pressure is spread over four rolls instead of two. Soft aluminium wire and tubular flux-cored wire keep their shape, and the feed stays steady on long torch cables. The spool bay takes 300 mm spools, and the case is powder-coated steel with a recessed front panel that protects the controls when the machine is moved around.
Inverter technology keeps the weight down and makes the machine tolerant of small supply variations. That is why it runs well on site generators, provided the generator is sized correctly. A thermostat-controlled fan only runs when the machine needs cooling, which keeps grinding dust out of the electronics.
Choosing the right model
Match the model to the thickest material you weld often and to the supply you have. The 200 A and 250 A models suit steel up to about 8 and 10 mm in multiple passes, and they work on single phase. The 350 A and 400 A models need a three phase 400 V supply and are the right choice for continuous production welding, 1.2 mm wire and plate above 10 mm.
This model is rated at 30% at 250 A. If you regularly weld for more than a few minutes without a break, choose a model with a higher duty cycle rather than running a smaller one at its limit.
Use and care
Blow dust out of the case with dry compressed air every few months and more often in grinding areas. Check drive roll grooves and the torch liner when you change wire size, and replace contact tips as soon as the bore wears oval. Keep the gas hose and earth clamp in good condition, as a poor earth causes more problems than any setting.
On the single phase models, use the plug supplied and avoid long extension leads, which drop the voltage and limit output.
Compliance and ordering
The machine is designed and tested to IEC 60974-1 and IEC 60974-10 and is CE and UKCA marked. It ships with a Euro torch, earth lead, gas hose and drive rolls fitted. Trade account holders can add regulators, torches and wire to the same order through quick order, and spare parts are listed on this page under related products.
Demo product: invented for the Cartenvo B2B demo store.