Product overview
The Galecore 10 hp rotary screw compressor is designed for businesses that need air from the start of the shift to the end. Instead of pistons, two meshing rotors compress the air smoothly and continuously, so the machine can run at full load all day without overheating.
A refrigerated dryer is built in. It cools the compressed air to remove most of the water before it reaches your pipework, tools and spray guns, which means fewer rust problems and better paint finishes.
Because the airend has few wearing parts, a well-serviced screw compressor can run for tens of thousands of hours. It also uses less electricity per litre of air than a piston machine worked hard, which shows on the bill over long shifts.
Key features
- 100% duty cycle
- Integrated refrigerated dryer
- Controller with service reminders
- Installed and commissioned
Where to use it
Screw compressors pay back where piston compressors would run flat out or need replacing every few years.
- Vehicle body and paint shops
- Production lines with air cylinders and blow-off
- Joinery and furniture makers with several spray stations
- Packaging and food plants (with suitable filtration)
- Busy multi-bay vehicle workshops
Design and construction
The airend, motor, cooler and dryer sit inside a steel cabinet lined with sound-absorbing foam, mounted on the receiver to save floor space. Noise is low enough to install the compressor in the workshop itself rather than in a separate room.
The electronic controller shows pressure, temperature and running hours, and gives service reminders for the oil, filters and separator. It can start and stop remotely, and switches the motor off after a set time running unloaded to save energy.
Sizing your system
We size the compressor from your actual demand. Our survey looks at your tools, the hours you work and the pipework, and we can log your current compressor's running pattern if you have one.
- 10 hp: two to three paint or production stations
- 20 hp: larger shops with several bays and spray booths
- Add filters at the point of use for paint and food work
- Leaks in pipework often waste 20% or more of the air
Installation and servicing
Our engineers install the compressor, connect it to your pipework and electrical supply through your electrician, and commission it. Allow good ventilation around the cabinet, as the compressor gives off heat while running. The condensate from the dryer must go to an oil-water separator, not the drain.
Service it every 4,000 hours or yearly with fresh oil, filters and a separator element as needed. A service plan keeps the warranty on the airend valid.
The controller keeps a record of faults and service work, which helps you plan maintenance around production.
Quotes and ordering
Screw compressors are priced on request after a short survey. Account customers can request a quote from this page and track it under their account.
The quote lists the compressor, filters, pipework and commissioning separately, and can go to your company's approver from your account if orders need sign-off. Service plans can be added to the same quote.
Demo product: invented for the Cartenvo B2B demo store.