Product overview
The Galecore HVLP spray gun uses a high volume of air at low pressure at the cap. That atomises the paint finely while keeping overspray down, so more paint ends up on the job and less in the booth or on the filters.
The gravity-feed cup sits on top of the gun, so the paint flows to the nozzle on its own and the gun empties the cup almost completely. The 1.4 mm nozzle sets which materials it handles best.
HVLP guns use less paint per job than conventional guns. That saves material, means fewer booth filter changes and keeps the workplace cleaner.
Key features
- HVLP, 600 ml cup
- Fan, fluid and air controls
- Stainless needle and nozzle
Where to use it
It suits small and medium spraying jobs in workshops and booths.
- Vehicle refinishing and panel repair
- Kitchen doors and furniture
- Machinery and equipment refurbishment
- Metal fabrications and gates
- Joinery primers and lacquers
Design and construction
The body is forged aluminium with an anodised finish that resists solvents and cleans easily. The needle, nozzle and air cap are stainless steel, so the gun works with both solvent-based and waterborne paints.
Three controls at the back of the gun set the fan width, the fluid flow and the air pressure. The 600 ml acetal cup has a filter and a drip-proof lid, and the gun hangs on a hook on the cup when you put it down.
The balanced body and a light trigger pull reduce hand fatigue over a long day, and the cup threads onto the gun so it cannot work loose while spraying.
Choosing the nozzle size
Thin materials need a small nozzle to atomise finely. Thick materials need a larger one to flow freely without thinning too much.
If you spray both primers and top coats, keep one gun of each size for its own materials. That avoids contamination between coats and saves time on cleaning.
- 1.4 mm: base coats, clear coats, enamels and thin primers
- 1.7 mm: high-build primers, sealers and thicker coatings
- Check the paint maker's data sheet for the recommended size
- Spare nozzle sets let you change size later
Setup, use and cleaning
Feed the gun with clean, dry air through a filter and regulator. Set around 2 bar at the gun inlet with the trigger pulled, then fine-tune the fan and fluid controls on a test panel. Hold the gun 150 to 200 mm from the surface and keep it square to the work.
Clean the gun straight after use with the right thinner or water for the paint. Take out the needle and nozzle to clean them, but never soak the whole gun, as solvents damage the seals. A drop of gun lubricant on the needle and threads keeps it smooth.
Packaging and ordering
Each gun comes with a cleaning brush and spanner. Trade customers can add spare cups, nozzle sets and air filters in one order with quick order.
Gun cleaning kits, paint strainers and cup lids are also available, and frequent orders can be saved as a list for quick reordering.
Demo product: invented for the Cartenvo B2B demo store.