Product overview
The Galecore 3 hp belt-drive compressor is a workshop machine meant to run every day. A cast-iron, oil-lubricated pump turns at a modest speed through a V-belt, so it stays cool, wears slowly and is much quieter than a direct-drive compressor of the same output.
It delivers 340 L/min up to 10 bar into a 100 litre receiver. The large tank evens out demand, so the motor starts less often and air tools get a steady supply.
Because the pump runs slowly, it sends cooler air to the tank and passes less oil into the line. That means less water in your pipework and a longer life for the valves, belt and motor.
Key features
- Cast-iron pump, oil lubricated
- Automatic pressure switch and gauges
- Belt guard and safety valve
- Tank certified to AS 1210
Where to use it
Choose a belt-drive compressor when air is part of the working day rather than an occasional job.
- Vehicle workshops running impact wrenches, ratchets and tyre inflators
- Body shops and joinery shops with spray guns and sanders
- Fabrication shops for blow-down, air grinders and plasma cutters
- Farm and fleet workshops
- Small production lines with several air stations
Design and construction
The pump has cast-iron cylinders, finned for cooling, with an aftercooler pipe that takes heat out of the air before it reaches the tank. The larger models use a two-stage pump, which compresses the air in two steps to reach 12 bar efficiently. A full belt guard covers the pulleys and belt.
Every model has an automatic pressure switch, a tank gauge and a regulated outlet gauge, a safety valve and a drain at the lowest point of the tank. The welded steel tank is certified as a pressure vessel and comes with its own test certificate.
Choosing the right model
Add up the air use of the tools that will run at the same time, then add about 30% for leaks and future needs. Compare that figure with the air delivery, not the displacement.
- 3 hp, 100 L: one or two users with impact wrenches and blow guns
- 5.5 hp, 200 L: a busy bay or a spray booth with one gun
- 10 hp, 300 L: several bays or continuous sanding and spraying
- The 5.5 hp and 10 hp models need a three-phase supply
Installation and care
Stand the compressor on a level floor in a cool, ventilated place with at least 500 mm of space around the pump. Three-phase models must be connected by an electrician, who should check the direction of rotation before first use. Fit an isolator and a filter regulator at the point of use.
Drain the tank daily, check the oil weekly and change it every 500 hours with a compressor oil. Clean the intake filter monthly and check belt tension every three months. Have the tank and safety valve inspected as required by your written scheme of examination.
Delivery and ordering
Compressors are delivered on a pallet with oil supplied in a separate bottle. Trade account holders can add hoses, couplers, filters and spare belts in one order with quick order.
Demo product: invented for the Cartenvo B2B demo store.