Product overview
The Galecore 1/2" air impact wrench uses a twin-hammer mechanism: two hammers strike the anvil on each turn, which gives a smoother, more even blow than a single hammer. The result is high torque for stubborn fasteners, with less vibration and kickback in the hand.
A power regulator gives three settings in forward. Reverse always runs at full power, so seized nuts come off quickly, while lower forward settings help you avoid over-tightening.
The 1/2" square drive takes standard impact sockets, and the compact head reaches into wheel arches and engine bays. A hanger loop lets you hang it from a balancer on a busy bay.
Key features
- Twin-hammer mechanism
- Three power settings, forward and reverse
- Needs 120 L/min at 6.2 bar
Where to use it
Pick the drive size to suit the fasteners you work on most.
- 1/2 inch: car and van wheel nuts, suspension and engine bolts
- 3/4 inch: truck, bus and plant wheel nuts, structural steel
- Tyre bays and mobile tyre services
- Agricultural and fleet workshops
- Dismantling seized fasteners in maintenance work
Design and construction
The housing combines a hard-wearing aluminium front with a composite grip that stays warm in cold workshops. The exhaust is directed down through the handle, away from the work and the operator's face. The trigger is variable, so you can start nuts slowly.
The 1/2 inch model has a friction ring anvil for quick socket changes. The 3/4 inch model has a pin and O-ring anvil that holds heavy sockets securely.
Both models are balanced so the weight sits over the grip, which reduces wrist strain when you work at arm's length or overhead under a lifted vehicle.
Air supply and setup
Impact wrenches need a good volume of air at around 6.2 bar at the tool. A small compressor or a narrow hose will rob the tool of power, so check your supply before blaming the wrench.
- Use at least a 10 mm bore hose, kept as short as practical
- Fit a filter, regulator and lubricator, or oil the tool daily
- Set 6.2 bar at the tool inlet while it is running
- Use impact-rated sockets only
Use and care
Put a few drops of air tool oil in the inlet before each day's use, unless the line has a lubricator. Drain water from the air line regularly; water in the motor causes rust and loss of power. Grease the hammer mechanism through the grease port every few months.
Do not use an impact wrench for final tightening of wheel nuts. Run them down, then tighten to the vehicle maker's figure with a torque wrench.
If the wrench will not be used for a while, store it clean and dry with a few drops of oil in the inlet.
Ordering for workshops
Each wrench comes with an inlet fitting, a bottle of air tool oil and the manual. Workshops can add impact sockets, hoses and couplers to the same order with quick order, and tier prices apply on multiple tools.
Spare anvils, hammer kits and trigger valves are available, so a worn wrench can be rebuilt in the workshop rather than replaced.
Demo product: invented for the Cartenvo B2B demo store.