Overview
A frame anchor lets you fix a timber or uPVC frame to the wall in one go. You set the frame in position, drill through it and into the masonry behind, push the anchor through and drive the screw. Because the sleeve passes through the frame, the frame does not need packing out or temporary support while you fix it, and it will not be pulled out of line.
Each Forgeline anchor comes as one piece: a polyamide sleeve with a zinc plated countersunk screw already started in it, so there are no loose parts to lose on a ladder. Fitters can carry a box on the belt and fix a whole frame without going back to the van.
Sold in packs of 50 anchors.
Where to use it
Frame anchors are the standard fixing for:
- Window and door frames, timber and uPVC
- Door linings and casings
- Timber battens and ground bearers on masonry walls
- Handrail brackets and wall plates
- Fixing through insulation boards to masonry
Design and construction
The sleeve has a long plain shank that passes through the frame and an expansion zone at the tip with anti-rotation ribs. As the screw is driven, the expansion zone opens and grips the hole. In solid materials it expands; in hollow brick and block it spreads across the webs for a secure hold.
The countersunk screw head sits flush with the frame face so it can be capped or filled. The 8 mm anchors use a T30 screw and the 10 mm anchors a T40, both of which are less likely to cam out than a cross-head screw at the end of the drive.
Choosing the right size
The anchor length is the fixture thickness plus the depth it must go into the wall. The 8 mm anchors need 50 mm in the masonry and the 10 mm anchors 60 mm, so subtract that from the length to get the thickest frame you can fix. The maximum fixture thickness for each size is in the specifications.
Choose 8 mm for standard window frames and linings. Choose 10 mm for heavier door frames, softer masonry or where you want a larger safety margin.
Installation
Drill through the frame and into the wall with a masonry bit the same diameter as the anchor, using hammer action only in solid materials. Drill at least 10 mm deeper than the embedment depth and clear out the dust. Tap the anchor in until the collar is flush with the frame, then drive the screw until the head sits flush. Do not overtighten; the frame should not bow.
Keep to the edge and spacing distances in the specifications, especially in brick, to avoid cracking the masonry near reveals.
Packaging and ordering
Anchors come boxed in 50s with a size and barcode label. Window fitters and joiners often order 8 mm and 10 mm sizes together with masonry bits; trade customers can add both in one quick order and see tier pricing on larger quantities.
Demo product: invented for the Cartenvo B2B demo store.