Overview
The Edgecraft 25-piece drill bit set holds HSS jobber bits in half-millimetre steps from 1 mm or 1.5 mm upwards. Each bit sits in its own marked slot, so you can see straight away which size is missing.
It is the practical choice when you need many sizes occasionally, rather than a lot of one size. Workshops often keep one set per bench and buy the busy sizes in packs of 10.
What it is for
The bits suit general drilling in metals, plastics and wood with hand drills, cordless drill drivers and pillar drills.
- Clearance holes for metric bolts and machine screws
- Tapping holes, for example 6.8 mm for M8 or 8.5 mm for M10
- Pilot holes for wood screws and self-tapping screws
- Sheet metal, brackets and light sections
- Maintenance and repair work across a site
Design and construction
All bits are ground from M2 high-speed steel with a 135° split point that starts without a centre punch on most surfaces. The dimensions follow DIN 338 jobber lengths.
The case is pressed steel with a positive catch and a hinged rack that tilts up for easy picking. Sizes are stamped on the rack and on the shank of each bit above 3 mm.
Which set to choose
The 13-piece set runs from 1.5 to 7.5 mm and covers most screw and small bolt work. The 19-piece set runs from 1 to 10 mm, which adds the M8 and M10 tapping and clearance sizes. The 25-piece set runs from 1 to 13 mm for heavier fabrication and bolting.
Replacement bits in the common sizes are available in packs of 10, so a set does not have to be replaced when one size wears out.
Speeds and materials
High-speed steel is forgiving, but heat is still its main enemy. As a rule, a 3 mm bit can run at about 2,600 rpm in mild steel, a 6 mm bit at about 1,300 rpm and a 10 mm bit at about 800 rpm. Halve these speeds for stainless steel and roughly double them for aluminium and plastics.
If the bit squeals, smokes or produces blue chips, it is running too fast or the feed is too light. A steady feed that produces curled chips is right. In thin sheet, clamp the work to a piece of scrap timber to stop it grabbing as the bit breaks through.
For timber, the bits work well at higher speeds. In hardwood, back the bit out now and then to clear the flutes. The 25-piece case also makes it easy to check which size you used last, so pilot and clearance holes stay consistent across a job.
Use and care
Run small bits fast and large bits slowly, and use cutting oil when drilling steel. Clamp the work and wear safety glasses. Wipe the bits and close the case after use so the rack stays tidy.
Trade customers can add sets to a saved list or reorder them with quick order alongside fixings and consumables.
Demo product: invented for the Cartenvo B2B demo store.