Overview
The Torqline 18 V drill driver is the everyday cordless tool for installers and maintenance teams. Its brushless motor delivers up to 50 Nm of torque and runs longer on a charge than a brushed motor of the same size.
This version is supplied body only. The body-only version suits anyone who already owns Torqline 18 V batteries. The kit adds two 2.0 Ah batteries, a fast charger and a carry case.
Where to use it
It handles most drilling and fixing jobs that do not need hammer action.
- Driving wood screws into timber and board
- Fixing brackets, hinges and fittings
- Drilling steel with HSS bits up to 13 mm
- Drilling timber with flat or auger bits up to 38 mm
- Assembling racking, cabinets and furniture
Key design points
Two gears give a slow, high-torque speed for driving and a fast speed for drilling. A 20-step clutch plus a drill setting stops screws at the same depth every time and avoids stripping heads. The 13 mm all-metal keyless chuck holds round and hex shanks firmly.
An LED under the chuck lights the work, a belt hook can be fitted to either side, and a battery gauge shows the remaining charge. Electronic protection stops the tool if the battery or motor overheats or the battery runs flat.
Batteries and charging
The drill uses Torqline 18 V lithium-ion slide-on batteries. Any battery from that platform fits, and larger batteries extend run time at the cost of some extra weight. The kit charger fills a 2.0 Ah battery in about an hour.
Store batteries part charged in a cool, dry place, and do not leave them on a hot dashboard.
Bits, speed and torque
Use the low gear for driving screws and for drilling large holes, and the high gear for small holes in wood and metal. Start slowly with the variable-speed trigger until the screw or bit has bitten, then increase speed.
For screws, use a good-quality impact-rated bit in a magnetic holder. Match the bit to the screw recess, usually PZ2 for wood screws, and keep the drill in line with the screw. If the clutch slips before the screw is home, turn it up one or two settings rather than straight to the drill setting.
For steel, use HSS bits with cutting oil and the low gear for holes above 8 mm. The 13 mm chuck holds round shanks up to 13 mm and 1/4 inch hex bits directly. For masonry beyond soft brick, switch to an SDS hammer drill, as forcing a drill driver into concrete overheats the motor and wears the bit.
Safety and compliance
The drill driver is CE and UKCA marked and tested to EN 62841-1 and EN 62841-2-1. Keep loose clothing clear of the chuck and wear safety glasses when drilling. Use the low gear and a firm grip for large holes, as the tool can twist if the bit jams.
Trade customers can add bits, screws and spare batteries to the same order through quick order.
Demo product: invented for the Cartenvo B2B demo store.