Overview
Castors take a lot of punishment on cleaning machines. They run through water and detergent every day, bump over thresholds and lift kerbs, and carry the weight of full tanks. A worn or seized castor makes a machine hard to steer, drags the squeegee off line and leaves black marks on the floor you have just cleaned.
This swivel castor is a direct replacement for the original, with the same top plate and hole pattern so it bolts straight on.
Where to use it
The castors fit Scrubtec walk-behind scrubber dryers, tub and wet-and-dry vacuums, and cleaning and housekeeping trolleys. They also suit general equipment that is moved by hand indoors, such as tool trolleys and stands, where a non-marking wheel matters.
- 75 mm: vacuums and light trolleys
- 100 mm: scrubber dryer squeegee and rear castors, trolleys
- 125 mm: heavier machines and loaded trolleys
- Indoor use on hard floors
Design and construction
The tyre is grey thermoplastic rubber, moulded onto a polypropylene wheel centre. It is soft enough to roll quietly and grip smooth floors, yet doesn't leave marks or pick up grit. The wheel runs on a roller bearing, and the swivel head has a double ball race so it turns easily under load.
The fork and top plate are zinc-plated pressed steel, and the bearings are greased for life. All metal parts resist the detergents used in floor cleaning, but should be rinsed off after wet work.
Choosing the size
Replace like for like: measure the wheel diameter and the top plate hole centres of the old castor, and compare them with the specifications. A larger castor changes the height of the machine, which on a scrubber dryer affects the squeegee and brush pressure. Check the load capacity too; with four castors, allow for the full weight of the machine with tanks filled.
Fitting and care
Drain the tanks and support the machine securely before removing the old castor. Fit the new one with all four bolts and lock nuts or thread-locking compound, as vibration can loosen fixings over time.
Remove hair and string from the axle and swivel weekly, and rinse off detergent residue. Replace a castor when the tyre is flat-spotted, cracked or comes away from the wheel centre.
Check the swivel at the same time. A swivel head that wobbles or binds has worn ball races, and the castor should be replaced even if the tyre still looks good. On scrubber dryers, replace the castors either side of the squeegee as a pair so it stays level.
Ordering
Castors are packed singly with the size and part code on the label. Order them in fours for trolleys, or keep a few spares for the most common size in your fleet. Trade accounts can reorder by part code with quick order.
Demo product: invented for the Cartenvo B2B demo store.