Overview
A through bolt, also called a wedge anchor, is the quickest way to make a strong mechanical fixing into concrete. The anchor is pushed through the fixture into a drilled hole. As the nut is tightened, a cone at the tip draws up into a steel expansion clip, which presses hard against the sides of the hole and locks the anchor in place.
These Forgeline anchors are made from zinc plated steel and come complete with a hex nut and a washer, so each one is ready to fit straight from the box. Because the anchor takes load as soon as the nut is tightened, equipment can be used the same day with no waiting for resin to cure.
Sold in packs of 25 bolts.
Where to use it
Through bolts suit medium and heavy fixings into solid concrete:
- Pallet racking base plates and column guards
- Machinery, workbenches and compressor feet
- Steel brackets, ledgers and support frames
- Handrails, barriers and gate posts
- Cable tray and pipe support stands
Design and construction
The bolt has a rolled metric thread at the top and a machined cone at the bottom. The expansion clip is held in place on a reduced section of the shank, so it cannot slide off during handling. Because the anchor passes through the fixture, the holes in the item and the concrete are drilled in one go and always line up.
Once set, the anchor cannot be removed, but the nut can be taken off to lift the fixture and refitted later.
Choosing the right size
The anchor diameter equals the drill size: an M10 anchor needs a 10 mm hole. Choose the diameter from the load, then the length from the thickness of the item being fixed. The maximum fixture thickness, minimum hole depth and suggested working loads for each size are in the specifications.
These anchors are for non-cracked concrete of grade C20/25 or stronger. For brick, block or hollow materials use resin anchors or frame anchors instead. For safety-critical or overhead fixings, use an anchor with a European Technical Assessment and follow the engineer's design.
Installation
Drill a hole of the anchor diameter to at least the minimum depth, using a sharp SDS bit and hammer action. Clean the hole thoroughly with a blow pump and brush; dust left in the hole is the main cause of poor holding. Place the fixture, tap the anchor through until the washer touches it, then tighten the nut to the installation torque with a torque wrench.
Keep to the minimum edge distance, spacing and concrete thickness, otherwise the concrete can crack as the anchor expands.
Packaging and ordering
Anchors are boxed in 25s with the nut and washer fitted. Racking installers and maintenance teams often order the anchors with SDS bits in the matching size; trade customers can add both in one quick order, and tier prices apply to larger quantities.
Demo product: invented for the Cartenvo B2B demo store.