Overview
The Torqline 1200 mm spirit level is made for setting out and installing on site. The box-section aluminium body is rigid and light, and the base is milled flat so the level sits true on timber, steel and masonry.
Three acrylic vials read level, plumb and 45°. The main level vial is set into the body and adjusted at the factory to 0.5 mm per metre.
Where to use it
It suits carpenters, builders, electricians, plumbers and shopfitters.
- Setting doors, frames and windows plumb
- Hanging shelves, cabinets and radiators
- Fixing sockets, switches and trunking level
- Laying out brackets and pipe runs
- Checking floors, walls and worktops
Design and construction
The box profile, 56 mm high and 25 mm wide, resists bending and twisting, so the reading stays accurate over the full length. The vials are UV-stable and have green liquid with black rings for easy reading in poor light. The level vial can be read from above as well as from the side.
The 1200 mm level has two hand holes so you can grip it with gloves. Rubber end caps soak up impacts and stop the level sliding on smooth surfaces.
Choosing the length
The 600 mm level fits in a tool bag and is the right size for sockets, shelves and short runs. The 1200 mm level spans more of the surface, so it averages out bumps and is the better choice for door frames, worktops and studwork.
Many installers carry both: the short level for fixtures, the long level for structures.
Reading the vials
The bubble is level when it sits exactly between the two black rings. If it touches one ring, the high end is the side the bubble has moved towards. For plumb, hold the level against the vertical face and read the vial nearest your eye line.
For long runs such as a row of cabinets, work from a datum line rather than levelling each unit on its own. Mark a level line along the wall with the long level, then check each fixing against it. Small errors from one unit to the next then cannot build up.
The 45° vial helps with handrails, braces and pipe offsets where a common angle is needed. For any other slope, use the level with a gauge or packing under one end. Hold the 1200 mm level by the body, not by the end caps, so you do not lift one end off the work while reading it.
Checking and care
Check accuracy now and then. Place the level on a flat surface and note the bubble, then turn it end to end in the same spot. The bubble should read the same both times. If it does not, the level has been damaged and should be replaced.
Keep the base clean and free of plaster and adhesive. Store it flat or hanging, never leaning against a wall where it could bend.
Demo product: invented for the Cartenvo B2B demo store.