Overview
O-rings are the cheapest seals in a machine and among the most common reasons for a leak. A flattened, cracked or nicked O-ring in a hose coupling, filter bowl or pump can stop a job, and waiting for one specific size wastes time. A sorted kit means the right ring is in the van or on the bench.
This kit holds nitrile O-rings in common metric sizes, sorted in a compartment case with a size chart in the lid.
Where to use it
Nitrile is the general-purpose O-ring material for oil, grease, water and air. The kit is used by maintenance teams, mobile engineers and workshops for everyday repairs.
- Pressure washer couplings, guns and lances
- Scrubber dryer solution valves and filter bowls
- Air tool and compressed air fittings
- Hydraulic and lubrication fittings
- Pumps, valves and plumbing fittings
Choosing the kit
The 225-piece kit holds 18 sizes from 3 to 22 mm inside diameter, in 1.5, 1.9 and 2.4 mm sections. It covers small fittings, couplings and air tools. The 386-piece kit holds 30 sizes from 3 to 50 mm inside diameter, with larger 3.1 and 3.5 mm sections, and adds the bigger rings used in filter housings, pumps and hydraulic parts.
Smaller sizes, which get used most, come in larger quantities in both kits.
Material and construction
All rings are moulded in 70 Shore A nitrile rubber, the standard hardness for static and light dynamic seals. They suit mineral oils, greases, water, air and most hydraulic fluids from -30 to +100 °C. Nitrile is not suitable for brake fluid, ozone, strong solvents or petrol with high ethanol content.
The case is polypropylene with a hinged clear lid and fixed dividers, so sizes don't mix when it is carried around.
Fitting tips
Measure the inside diameter and cross-section of the old ring, or the groove, with a caliper. Clean the groove, lightly lubricate the new ring with the fluid it will seal or a little silicone grease, and roll it into place without twisting. Avoid sharp edges and threads, which cut the ring as it goes on.
Never reuse an old O-ring once a joint has been opened. A ring that has taken a set will not seal again properly, and a new one costs almost nothing.
- Always fit a new ring when a joint is opened
- Never stretch a ring more than about 5%
- Use a plastic pick, not a screwdriver
Ordering and refills
Kits are boxed with a printed size chart. Trade accounts can save the kit to an order list for each service van, and order a fresh kit when the most used compartments run low.
For hot water above 100 °C, petrol, brake fluid or chemicals, a nitrile ring is the wrong choice. In those cases use the seal supplied with the part, or ask us for a ring in a suitable material.
Demo product: invented for the Cartenvo B2B demo store.