Overview
The torch is the part of a MIG welder that takes the most wear. Cables get crushed, liners clog and handles crack. This Spatterline torch is a direct replacement for any machine with a Euro (central) connector, and it comes with a contact tip, tip holder, gas nozzle and steel liner fitted, so you can connect it and weld.
It is also a sensible upgrade. A longer cable gives more reach on site, and a higher-rated torch runs cooler at the same current.
Key features
- Euro connector
- Contact tips and shroud fitted
- Liner suits 0.8–1.2 mm steel wire
Choosing the right torch
Choose the rating by the current you weld at, not the maximum of the machine. A torch running near its rating gets hot, and contact tips wear faster. Choose the length by how far you need to reach: a 3 m cable feeds wire most reliably, especially soft aluminium wire, while a 4 m cable gives more freedom around large work.
- 250 A: welders up to about 250 A, sheet and general fabrication
- 360 A: three phase welders, thicker plate and long runs
- 3 m: the best wire feed, ideal for aluminium
- 4 m: more reach on site and around large parts
Design and construction
The swan neck is a brass tube with an insulated cover, shaped to give good access to fillet and corner joints. A ball joint at the back of the handle lets the cable swing freely, which reduces the pull on your wrist. The cable is a coaxial design with a tough outer sheath that resists spatter and abrasion. The Euro connector has a brass body and a gas seal, and tightens by hand.
Fitting and liners
The torch comes with a steel liner for 0.8 to 1.2 mm steel and stainless wire. For aluminium wire, fit a PTFE or carbon liner, and use a contact tip one size larger than the wire. When fitting a new liner, lay the cable out straight and trim the liner flush with the tip holder so the wire cannot snag.
Before connecting, check that the wire drive rolls on your welder match the wire size you are using.
Care and consumables
Most feed problems start at the torch. Clean spatter from the nozzle regularly, and use anti-spatter spray or gel to slow the build-up. Replace contact tips when the bore wears oval or the arc starts to wander. Blow the liner through with dry compressed air each time you change a spool, and replace it when the wire starts to drag. Keep the cable as straight as possible while welding.
Contact tips, nozzles and liners are sold separately in trade packs.
Compliance and ordering
The torch is designed to IEC 60974-7 and is CE and UKCA marked. Trade customers can order torches and consumables together, buy on account and save a quick order list for regular tip and nozzle top-ups.
Demo product: invented for the Cartenvo B2B demo store.