Overview
The Edgecraft jigsaw blade range covers the three materials trade users cut most: wood, metal and laminate. This pack holds five Wood blades, each with a T-shank that locks into the quick-change clamp of corded and cordless jigsaws.
Each blade type uses the steel and tooth geometry that suits its material, so it cuts faster and lasts longer than a general-purpose blade.
The three blade types
Choose by material first, then by the finish you need.
- Wood: high-carbon steel, 6 TPI set and ground teeth for fast cuts in timber and board up to 50 mm
- Metal: bi-metal, 21 TPI wavy set for sheet steel, aluminium and pipe from 1 to 3 mm
- Laminate: high-carbon steel, 20 TPI reverse teeth that cut on the down stroke for a chip-free top face
- All three carry the type and material on the shank
Design and construction
Wood blades have widely spaced, set teeth that clear sawdust quickly. The metal blade is bi-metal: a high-speed steel tooth edge welded to a flexible spring steel body, so it resists both wear and snapping. The laminate blade has its teeth pointing towards the shank, which pushes the top surface down instead of lifting it.
The T-shank has a shoulder that locates the blade in the clamp, so it stays straight and does not pull out under load.
Using the blades
Set the pendulum action high for fast cuts in softwood, and off for metal, laminate and curves. Run metal blades at lower speed with a little cutting oil. Clamp thin sheet between boards to stop it vibrating.
When using the laminate blade, cut with the decorative face up. Remember that a reverse-tooth blade pushes the saw away from the work, so hold the saw firmly against the surface. Change a blade when it starts to wander or burn.
Choosing the right blade
The rule of thumb is to keep at least three teeth in the material at all times. That is why the metal blade has fine teeth for thin sheet, while the wood blade has coarse teeth for thicker timber. Too few teeth in contact make the blade snag and break; too many make it clog and burn.
Use the wood blade for studs, joists and rough cuts in board where speed matters more than finish. Use the laminate blade for worktop cut-outs, sink holes and laminated flooring where the top face must stay clean. Use the metal blade for sheet steel, aluminium profiles, copper pipe and plastic trunking.
If you cut plastics such as PVC or acrylic, the metal blade at low speed usually gives the best result, as faster blades can melt the edge. The blades in this pack are Wood blades, marked on the shank, so they are easy to tell apart in a mixed tool box.
Ordering
Blades come in a hard plastic case of five. Teams that cut mixed materials often order all three types together with quick order, so each van carries a full set.
Demo product: invented for the Cartenvo B2B demo store.