Overview
A flat washer is the simplest part of a bolted joint and one of the most useful. It gives the nut or bolt head a smooth, hard face to turn on, spreads the clamping force over a larger area and stops the fastener digging into the surface underneath.
These form A washers follow ISO 7089, the normal series for general engineering. They are punched from low carbon steel, deburred and zinc plated with a clear trivalent passivate for a bright, clean finish.
Sold in packs of 200 washers.
Where to use it
Fit a flat washer under the turning part of almost any bolted joint, and under both ends where the surface is soft or painted:
- Steel brackets, frames and racking
- Timber, plywood and composite panels
- Painted, powder coated or galvanised parts
- Slotted or slightly oversized holes
- Threaded rod hangers and anchor fixings
Design and construction
Form A washers have a moderate outside diameter and thickness, roughly twice the bolt size across and about a quarter of the diameter thick. They are hard enough at around 200 HV to support grade 8.8 bolts in normal joints without dishing.
The bore is made slightly larger than the thread, so the washer slides easily over the bolt and sits flat against the head or nut. Both faces are flat and free of sharp burrs.
Because every washer in a pack is the same thickness, stacked joints stay square and bolt lengths work out as planned. That makes them a good choice for shimming small gaps in brackets and frames as well as for ordinary bolting. Many fitters also use them under coach screws and anchor nuts when fixing into timber or concrete.
Choosing the right size
Choose the washer by the thread size of the bolt or screw: an M10 bolt takes an M10 washer. The inside diameter, outside diameter and thickness of each size are listed in the technical specifications.
If you are fixing into soft timber or thin sheet and need more bearing area, a wider penny or form G washer is a better choice. For joints that vibrate, add a spring washer or use a nyloc nut; a flat washer alone does not lock.
Fitting and care
Place the washer directly under the part you turn, normally the nut. Where you add a spring washer, it goes between the flat washer and the nut. Make sure the washer sits square and is not trapped on a thread or weld bead before tightening.
Zinc plated washers are for indoor or covered use. Outdoors, near the sea or in wash-down areas, match the bolt and use stainless washers so the whole joint resists corrosion. Store packs in a dry place to keep the plating bright.
Packaging and ordering
Washers come in labelled packs of 200 with the size and barcode on the label, which makes restocking van boxes and stores bins quick. Most buyers order them with matching bolts and nuts; trade customers can add all three in one quick order and see tier pricing in the basket.
Demo product: invented for the Cartenvo B2B demo store.