FAQs
How do I find the right belt if the code on my old one has worn off?
Check the parts list in your machine's manual, which gives the belt code for each drive. If you don't have it, measure the top width and the outside length of the old belt and compare them with the profile and length on this page. Our team can also help if you send the machine model and serial number.
My machine used the XPZ-800 belt. What do I order now?
The XPZ-800 has been replaced by the XPZ-850. Later machines use a revised pulley position, and the slightly longer belt fits both the old and new layouts once the tensioner is set.
How tight should the new belt be?
Set it so the belt deflects by about 1.5 per cent of the distance between the pulley centres under firm thumb pressure. Check it again after the first few hours, as a new belt beds in and loosens slightly.
How often should drive belts be changed?
There is no fixed interval; it depends on load and conditions. Inspect the belts every 250 running hours and replace any belt that is cracked, frayed, glazed or that keeps slipping after adjustment.
Can I fit a standard belt from a motor factor instead?
A general-purpose belt of the same profile and length will often fit, but it may not be antistatic or rated for the small pulleys used on scrubber dryers. This belt matches the original specification, so it lasts as long as the one fitted in the factory.
Can I keep spare belts on the shelf?
Yes. Stored in the bag, away from heat, sunlight and ozone sources such as electric motors, they keep for about five years. Hang or lay them flat; don't hang them from a nail, which kinks the cord.