Product overview
These gloves combine a seamless high-performance polyethylene (HPPE) knit with a thin polyurethane coating on the palm and fingers. The knit resists cuts from sharp edges while staying light and flexible; the coating adds grip without making the glove stiff.
The back of the hand is left uncoated so the glove breathes, which keeps hands cooler on long shifts.
Choosing the cut level
EN 388 rates cut resistance with the ISO 13997 test as a letter from A to F. Each letter stands for the force in newtons a blade needs to cut through the material. Choose the level from your risk assessment, not the highest number available: higher levels use heavier yarns and give a little less touch.
Level B suits general assembly and handling of light parts. Level C is a good all-round choice for sheet metal, HVAC ductwork and packaging lines. Level D suits glass handling, metal stamping and recycling. Level F is for the sharpest work, such as blade changing, sheet glass and fabrication with freshly cut edges.
- Level B: at least 5 N
- Level C: at least 10 N
- Level D: at least 15 N
- Level F: at least 30 N
Where to use them
Typical users include fabricators, glaziers, HVAC and ductwork installers, warehouse teams opening cartons with knives, and maintenance staff changing blades or handling machined parts. The PU coating works best in dry or lightly oily conditions.
Because the coating is thin, you can still pick up small screws, read labels and use a touchscreen without taking the gloves off. That matters on picking lines and assembly benches, where people who remove their gloves for fiddly tasks often forget to put them back on.
- Sheet metal and ductwork
- Glass and glazing
- Metal stamping and pressing
- Packaging lines and carton opening
- Waste sorting and recycling
Fit and sizing
Sizes run from 7 (small) to 10 (extra large). A close fit matters with cut gloves: loose fingertips reduce control of the part you are holding. Measure around the palm below the knuckles: about 18 cm is a size 7, 20 cm a size 8, 22 cm a size 9 and 24 cm a size 10.
Never wear any gloves near rotating machinery such as drills, lathes or saws, where a glove can be drawn in.
Care and replacement
The gloves can be washed at 40 °C with a mild detergent and air dried. Do not tumble dry, bleach or iron them, as heat and bleach weaken HPPE fibres. Check them before each shift and replace them if the coating is worn through, the knit is cut or the cuff has lost its elasticity.
Cut resistance protects against slicing edges. It does not stop puncture from needles or thin points, and no glove is cut-proof.
Packs and ordering
Gloves are sold in pairs and in packs of 12 pairs of one size. Many sites colour-code levels by area; the quick order form lets you order several levels and sizes in one basket, and trade accounts see their tier prices on pack quantities.
Demo product: invented for the Cartenvo B2B demo store.