Overview
The Edgecraft TCT blade fits handheld circular saws with a 190 mm blade. Each of its 24 teeth carries a brazed tungsten carbide tip, ground to an alternate top bevel for clean cuts across and along the grain.
The plate is laser cut and tensioned so it runs true at full speed. Expansion slots let it grow with heat without warping, and they cut down the ringing noise.
Where to use it
Use it for carpentry, first fix, shopfitting and general site cutting in timber-based materials.
- Softwood studs, joists and battens
- Hardwood boards and sills
- Plywood, OSB and chipboard sheets
- MDF and hardboard
- Not for metal, masonry or fibre cement
Choosing teeth and diameter
Fewer teeth cut faster and clear chips well, which suits ripping and rough carpentry. The 24-tooth blades are the site choice for framing and fast cross-cuts. The 48-tooth blades leave a cleaner edge with less breakout on sheet materials and visible work.
Always fit the diameter your saw is made for. The 165 mm blades have a 20 mm bore. The 190 mm blades have a 30 mm bore and come with reducing rings for 20 mm and 16 mm arbors. Check that the saw's maximum speed does not exceed the speed marked on the blade.
Fitting and safe use
Disconnect the battery or plug before changing the blade. Fit it with the teeth and the arrow pointing in the saw's direction of rotation, and make sure the reducing ring sits flat. Check that the lower guard returns freely.
Let the blade reach full speed before cutting, support both sides of the work and avoid nails and screws. Wear eye and hearing protection and use dust extraction indoors, particularly on MDF.
Design and construction
The tungsten carbide tips are brazed into seats cut in the steel plate and ground after brazing, so each tooth cuts at the same height. Carbide stays sharp many times longer than steel teeth in abrasive materials such as chipboard and plywood glue lines.
The thin kerf removes less material in each cut. That puts less load on the motor, which means more cuts per charge on cordless saws and less strain on corded saws. A lower hook angle on the 48-tooth blades gives a calmer, more controlled cut in sheet materials.
The blade is marked with its diameter, bore, tooth count, direction of rotation and maximum speed. These markings are required under EN 847-1, the safety standard for woodworking tools, and let you check at a glance that the blade suits the saw before you fit it.
Care and ordering
Resin build-up makes a blade run hot and cut slowly. Clean it with a resin remover and a brush. Carbide teeth can be resharpened several times by a saw doctor. Trade buyers can keep both tooth counts on a saved list and reorder them with quick order.
Demo product: invented for the Cartenvo B2B demo store.