Product overview
This is a full-brim-peak industrial safety helmet for construction, civil engineering, utilities and maintenance work. The ABS shell spreads the force of falling objects, and the six-point harness keeps a gap between shell and head so the energy of an impact is absorbed before it reaches the wearer.
Vents along the crown let warm air escape, which makes a real difference on summer sites and in plant rooms. The helmet weighs about 360 g, light enough that it does not drag on the neck through a long shift.
Choosing a colour
All six colours share the same shell, harness and rating. Colour is used on many sites to show roles at a glance, so check the scheme your client or principal contractor uses. A common pattern is shown below, but it is a convention, not a rule.
- White: managers, supervisors and engineers
- Yellow: general operatives and labourers
- Blue: visitors, technical advisers and some trades
- Orange: slingers, signallers and banksmen
- Green: safety officers and new starters
- Red: fire marshals and first aiders
Design and construction
The harness has six textile straps clipped into the shell, a replaceable foam-backed sweatband and a wheel ratchet at the back that adjusts from 53 to 63 cm head size, even while wearing gloves. A chinstrap with four anchor points can be added for work at height, where the helmet must stay on during a fall.
Standard 30 mm accessory slots on each side take clip-on ear defenders and visor carriers, and four clips on the shell hold a head torch strap. A rain gutter round the brim channels water away from the face and neck.
Fit and use
Set the harness height so the helmet sits level, about two fingers above the eyebrows, then tighten the ratchet until the helmet stays in place when you nod. Never wear a cap or hood under the harness, as it changes how the helmet sits and absorbs impact.
The helmet also meets the optional EN 397 requirements for very low temperature (-30 °C) and lateral deformation (LD), and for 440 V AC electrical insulation for brief accidental contact.
Care and replacement
Clean the shell with warm soapy water. Do not paint the shell, apply solvent-based stickers or store the helmet on a vehicle dashboard, since solvents and sunlight weaken ABS. Replace the sweatband when it becomes worn or unhygienic.
Replace the helmet after any significant impact, even if no damage is visible, and in any case about three years after first issue or five years from the date moulded inside the shell. Replace it sooner if the shell is cracked, chalky or faded.
Ordering and branding
Helmets are sold singly and in boxes of 20 of one colour. Trade accounts see their tier prices on boxes, and quick order lets you mix colours for supervisors, operatives and visitors in one order. Ask your account manager about printed company logos.
Demo product: invented for the Cartenvo B2B demo store.