Overview
A plain white plate switch that does its job quietly for years. Each gang has a common terminal and two switched terminals, so the same switch works on a single light point or on a staircase or corridor controlled from two places. The rockers have a positive action and a clear on and off position.
The plate is made from thermoset plastic that resists heat, scratches and the yellowing seen on cheaper accessories. The terminals are captive and backed out ready for wiring.
Where to use it
These switches suit almost any indoor lighting circuit.
- Rooms with one or several lighting circuits
- Stairs, landings and corridors with two-way switching
- Offices, classrooms and communal areas
- Rental properties and refurbishments
- Replacing damaged or discoloured switches
Design and construction
Each gang is a separate switch mechanism behind its own rocker, mounted on a steel grid inside the plate. The contacts are silver alloy, which keeps the contact resistance low and copes with the repeated make and break of lighting loads. The terminals are deep and clamp firmly on two 1.5 mm² conductors, which is enough for a loop at the switch or a pair of strappers.
The plate has a slim profile and slightly rounded edges, so it sits neatly on the wall and is easy to wipe clean. The fixing holes are slotted, which lets you level the plate when the back box is not quite straight.
Choosing the right switch
Choose the number of gangs from the number of separate lighting circuits or groups you want to control from one point. A 1-gang switch controls one circuit, a 2-gang controls two and a 3-gang controls three, all on a single plate. Every gang is 2-way, so there is no need to stock separate one-way switches.
The 10 A AX rating covers normal lighting loads, including LED drivers and fluorescent fittings with high inrush current. For dimming, use a dimmer switch that is matched to the lamps instead.
Installation and care
Isolate the lighting circuit and prove it dead. For one-way switching, connect the switch wire and the permanent line to the common and L1 terminals. For two-way switching, connect the strappers to L1 and L2 at both switches. Sleeve the earth in green and yellow and connect it to the back box earth terminal.
The switches fit a standard single back box. A box at least 16 mm deep suits the 1-gang and 2-gang; use 25 mm for the 3-gang, which has more conductors behind it. Clean with a damp cloth only.
- Label the strappers before disconnecting an old two-way switch
- Tighten every terminal firmly and check that no copper is exposed
- Test the circuit and record the results after installation
Compliance and ordering
The switches are made to BS EN 60669-1 and are CE and UKCA marked. Each comes boxed with two fixing screws. For housing and refurbishment projects they can be bought by the box, mixed with matching sockets in a quick order or a saved list.
Demo product: invented for the Cartenvo B2B demo store.