Overview
A sealed LED floodlight that replaces old halogen and metal halide fittings at a fraction of the energy. The body is die-cast aluminium with cooling fins on the back, which carry heat away from the LEDs and give them a long life. The front is toughened glass, sealed with a silicone gasket to IP65, so the light is protected against dust and water jets from any direction.
The floodlight lights instantly at full output, with no warm-up time, and is not affected by frequent switching. That makes it a good partner for a PIR sensor or a photocell.
Where to use it
Floodlights give a wide, bright spread of light over open areas.
- Yards, compounds and loading bays
- Car parks and access roads
- Building fronts and signage
- Construction sites, on a temporary frame
- Sports areas and gardens
Choosing the right power
The 20 W floodlight gives around 2000 lumens and suits doorways, paths and small gardens. The 30 W and 50 W models suit driveways, yards and building fronts. The 100 W model gives around 10,000 lumens and suits car parks, large compounds and loading areas when mounted at height.
Mounting height matters as much as power. A higher position spreads the light over a wider area and reduces glare for people walking towards the light. Aim the floodlight down, not out, to keep light on your site and away from neighbours and the road.
Design and construction
The stainless steel bracket lets you tilt the floodlight through a wide arc and lock it in place. The driver is sealed inside the body and protected against mains surges, which helps in exposed outdoor locations. A short rubber lead is fitted at the factory, so the light can be connected in a weatherproof junction box without opening the body.
The 6500 K cool white light gives good contrast for security cameras and makes surfaces and colours look crisp at night.
Installation and care
Mount the floodlight on a solid surface using fixings suited to the wall. Connect the lead in an IP-rated junction box with the cable entries facing down. The floodlight is Class I and must be earthed. Clean the glass once or twice a year to keep the output high, and check that the bracket bolts are tight.
- Isolate the supply before installation or maintenance
- Do not cover the cooling fins
- Use an RCD-protected circuit for outdoor lighting
Compliance and ordering
The floodlight is made to EN 60598-1 and EN 60598-2-5, the standard for floodlights, and is CE and UKCA marked. It is packed singly in a carton with the bracket fitted and fixing guidance printed inside the lid.
Site managers and contractors often fit several sizes on one project: smaller units over doors and larger units on the corners of a building. All four sizes can be combined in one order, and trade accounts see their tier prices as soon as they sign in. Armoured cable, isolators and junction boxes can go on the same order.
Demo product: invented for the Cartenvo B2B demo store.