Overview
A twin switched socket is the most fitted accessory in any UK installation, and this one is built for the trade. Both switches break line and neutral, so the appliance is fully disconnected when the socket is off. The outlets are shuttered, the terminals are captive and backed out ready for wiring, and the fixing screws are supplied.
Three finishes cover most jobs: white for new builds, rentals and offices, brushed steel for kitchens and commercial interiors, and black nickel for homes and hospitality where a darker accessory suits the scheme.
Where to use it
The socket fits standard UK back boxes, flush or surface mounted.
- Ring final and radial socket circuits
- New builds, rewires and landlord refurbishments
- Offices, classrooms and shop fit-outs
- Kitchens, where the metal finishes clean easily
- Replacing damaged or discoloured sockets
Design and construction
The white version has a thermoset plate that resists heat, scratching and discolouration. The metal versions have a steel plate with a durable finish and contrasting inserts; they are fitted with an earth terminal on the plate, which must be connected so the plate is earthed.
Terminals accept up to three 2.5 mm² conductors, which makes spurs from a ring straightforward. Two earth terminals let you keep the circuit protective conductor and the plate earth on separate clamps.
- Double-pole switching with clear on indicators
- Shuttered outlets that open only to a three-pin plug
- Slotted fixing holes to level the plate on a crooked box
Choosing a finish
White suits most rooms and is the easiest to match when you replace a single socket in an existing installation. It is also the most economical choice for large housing and office projects, where hundreds of accessories are fitted.
Brushed steel hides fingermarks well and suits kitchens, utility rooms and commercial interiors with stainless appliances. Black nickel has a deep, reflective finish with black inserts and is popular in living areas, hotels and restaurants. Both metal finishes are flat plates with a slim profile, so they sit close to the wall. If a project mixes finishes, order each SKU separately and label the boxes by room before they go to site.
Installation and care
Isolate the circuit and prove it dead before you start. Strip the conductors to suit the terminals, sleeve any bare earth in green and yellow and tighten every screw firmly. Use a back box at least 25 mm deep so the cables are not crushed behind the socket. Clean the plate with a damp cloth; avoid abrasive and solvent cleaners, especially on the metal finishes.
After installation, test polarity, continuity and insulation resistance, and record the results on the electrical certificate.
Compliance and ordering
The socket is made to BS 1363-2 and is CE and UKCA marked. Each socket comes boxed with fixing screws. For new builds and refurbishments the sockets can be ordered by the box through quick order, and trade tier prices apply automatically.
Demo product: invented for the Cartenvo B2B demo store.