Overview
Crimp terminals give a fast, reliable termination that does not loosen with vibration the way a twisted conductor under a screw can. These terminals have a seamless tinned copper barrel and a colour-coded PVC sleeve, so the size is obvious at a glance and the finished joint is insulated with no extra tape or heat shrink.
The colour shows the cable range: red for 0.5 to 1.5 mm², blue for 1.5 to 2.5 mm² and yellow for 4 to 6 mm². The type shows the job: rings fit over a stud or screw, spades slide under a screw head or onto a terminal post, and butt connectors join two conductors end to end.
Applications
Pre-insulated terminals are used wherever conductors are terminated on studs, screws or tabs, or joined in line.
- Vehicle, trailer and plant wiring
- Control panels and switchgear
- Earth bonding to studs and metal enclosures
- Appliance, motor and pump connections
- Extending or repairing short cable runs
Choosing the right terminal
First match the colour to the conductor size; a terminal that is too large will not grip, and one that is too small will cut strands. Then choose the type. A ring terminal is the safest choice on a stud, because it cannot slip off even if the nut loosens. A spade is quicker to fit and remove, which suits terminal strips that are opened often. A butt connector joins two conductors of the same size range.
Check the stud or screw size for ring terminals and the screw diameter for spades; the specifications list the hole size of each terminal.
For panels and vehicles it is worth standardising on a small set of terminals. Most wiring falls within the red and blue ranges, so packs of red and blue rings and spades, plus yellow rings for heavier earth and battery leads, cover the majority of jobs with one ratchet tool.
Crimping and inspection
Strip the conductor to the length of the barrel, insert it until the copper reaches the end of the barrel, and crimp with a ratchet tool fitted with dies of the matching colour. The ratchet only releases when a full crimp has been made, which gives consistent results across a team.
A good crimp holds firmly when the cable is pulled and shows no bare copper outside the sleeve. Pliers and hammer crimps are not reliable and should be avoided.
- Use one conductor per barrel unless the range allows two
- Do not solder a crimped joint; it makes the conductor stiff and brittle
- Fit heat-shrink sleeving over butt joints in damp locations
Packaging and ordering
Terminals come in packs of 100 in a resealable bag with a printed label showing type, colour and cable range. Packs of each size are easy to combine in one order, and regular lines can be reordered from a saved list or by SKU through quick order.
Demo product: invented for the Cartenvo B2B demo store.